Navigation: 
Start
Door Restrictor
|
|
|
|
 |
|
|
SAFE-X-IT Door Restrictor - Enough Tape for 3-4 Floors
The C.J. Anderson SAFE-X-IT™ Door Restrictor is designed to stop the opening of passenger elevator car doors when the elevator is outside of the unlocking zone. This meets the requirements of ASME A17.1, Rule 111.12.
In addition SAFE-X-IT™ provides advanced features not found on other restrictors on the market. It is these unique features which make this door restrictor comply with other requirements of A17.1 as well as solving problems not now addressed by A17.1. Some of the operating features and special functions of this Door Restrictor are below.
Emergency Release Buttons
This unique feature is designed to allow retraction of the door restrictor from outside the elevator in the event of an emergency. Emergency Release Buttons can be mounted on the side, top, or bottom of the cab, or in a remote location. This eliminates the necessity of gaining access to the top of the car and allows authorized emergency personnel entry to the cab.
Fire Service Override
This innovation disables the restrictor when Phase II is activated. This allows Firefighters to do their job safely without fear of being locked in the elevator.
Failure Design
This restrictor, as any electrical mechanical device, requires routine inspections to insure it is operating and aligned properly, that the backup battery is fully charged, etc. However, should the unit for some reason fail, the solenoid plunger will retract, releasing the door restriction. This design is deliberate as the circumstances which cause a failure could be of a disastrous nature. Releasing the door restriction permits the doors to operate normally. This prevents passengers from being trapped in the car and costly problems such as a door motor burn out from trying to open a locked door.
One Sensor Only
This sensor is used to activate the solenoid plunger when the elevator cab is in the safe unlocking zone. To insure positive reception the sensor holder allows for full horizontal and vertical adjustment. Pressure sensitive tape on the base of the sensor holder eliminates the necessity of mounting holes and hardware. For ease of installation and certain operation the unit comes with 2 inch wide reflector tape. For optimum placement the solenoid plunger mounting bracket is designed to be top or side mounted.
The above highlights are in addition to other features such as a 5 year battery with test button, 5 yards of two inch wide tape and flame retardant ABS enclosure.
[URL Label]
|
|
|
|
|
|
|
Product number: |
|
636-101
|
|
Unit of measure: |
|
each
|
|
|
|
